Having fun with printing…
Patrons can access downloadable PDFs of most stories, 4K versions of many images, and content that I chose not to publish publicly here.
Please consider donating to my Patreon in order to receive access. Click here to find out more.
I wanted to see whether the DAZ G8 male gens printed well and whether the geo-grafted forekin produced seamless geometry. I was very happy to discover that both were high quality geometry, and even the foreskin looks good inside.
I imported into 3DS Max and capped off the base to get a flat surface to stand it on and because I have heard that Cura (the slicing software) will only create models from closed shapes.
In retrospect, it would have been better if I had set the flat plane at an angle so that the genitals would dangle down when placed flat on a wall. However, this would create a print overhang that then requires loads of support material, which in turns requires lots of clean up and a less smooth finish.
Nevertheless, I think you’ll agree that even though this measures less than 2 inches (5cm) high, making the striping far more obvius than it really was, this is an excellent progression.
Leave a Comment